Eyewash and Shower Equipment
Eyewash and Shower Equipment
Viewing Page 16 of 17
(161 results)
Haws Corporation - HAW SP509SS - 1/4in x1/2in stainless steel 90 degree
Items #:
HAW SP509SS
Model SP509SS is a Type 304 stainless steel in-line 50 x 50 mesh water strainer that prevents debris from reaching the eye/face wash. Easily serviceable.
Haws Corporation - HAW SP75 - Floor flange CRP coated
Items #:
HAW SP75
Model SP75 is a 9" (22.9 cm) diameter gray epoxy cast-iron floor flange and 1-1/4" IPS hot-dipped glavanized tee. A foot treadle assembly can be used with this flange.
Haws Corporation - HAW SP93 - ABS plastic bowl
Items #:
HAW SP93
Model SP93 is a Safety Green 11" (27.9 cm) ABS plastic receptor resistant to damage from alkalies, salt solutions, oils and most acids. For use on most Eyewashes and Eye/Face Wash Stations series.
Haws Corporation - HAW SP95 - P-Trap for use with wall mounted eye
Items #:
HAW SP95
Model SP95 is a satin chrome-plated brass trap and tailpiece, 1-1/4" (3.2 cm) O.D. inlet x 1-1/2" IPS outlet.
Haws Corporation - HAW TWBS.EW.H - Instantaneous heater, flows to 2.5 GPM
Items #:
HAW TWBS.EW.H
It is ideal for areas where supply water temperatures fall below 60° F (15° C) while hot water is not present
System consists of an 20 KW electrical instantaneous water heater, a hot shutoff valve, a bypass valve, an in-line 50 x 50 mesh filter, and an outlet temperature gauge
Requires 45 - 90 psi (3 - 6 ATM) flowing pressure
Inlet and Outlet: 1/2" IPS.
Electrical Supply: 480 VAC, 3-phase, 3 wire and ground. 24 amp per phase (optional 208/240 3-phase available - ask for quote).
UL listed for indoor use only.
Haws Corporation - HAW TWBS.EWE - Low-lead, tempered water blending system
Items #:
HAW TWBS.EWE
A flow rate of 1 to 12 gpm (3.8 to 45.4 L) for better temperature control across the operating range
AXION's superior design and technology provide a complete safety solution for increased victim comfort.
Lowest internal pressure drop for this class of valve (advantage where supply pressure is low)
Wax based thermostat technology for fast response time with proven highly reliable temperature control
Highest Cold Water Bypass flow rate in the industry (83% of rated tepid flow rate)
Modular lead-free brass design with internal check stops
Over-sized valve seats resist failures caused by foreign matter
A new and efficient shuttle design eliminates valve binding
A custom funnel design improves temperature control at low flow rates
Outlet temperature is factory set to 85° F (29° C)
Tempered water: High temperature limit is factory set to 87° F (30° C)
Cold water by-pass valves are closed during normal operation, regardless of flow rate